Error Codes in your Top Load Washer:
|Error code||Error||Possible resolution|
|drn||Washer is not draining properly,||This can sometimes be an installation problem. You can watch a video on How to Install the Washer Drain Hose|
|F# E# or F##||System error code.||Press START/PAUSE once to clear the code, then press START/PAUSE again to restart washer. If the code doesn't clear, Contact Us or Schedule Service Online.|
|HC||Hot and cold inlet hoses have been installed incorrectly (reversed).||
This code will appear at the end of the wash cycle to indicate that the cold water hose is connected to the hot water inlet, and the hot water hose is connected to the cold water inlet.
Turn off the water supply, and reverse the hoses. Run another cycle to verify that the hoses are correct. See installation instructions for questions regarding the hose installation (find it in our Manuals and Literature page.)
|LdL||Lid is not locking.||
It's possible that an item in the load may be keeping the lid from locking. Check for items directly under the lid. Also check for detergent build up around the lid lock mechanism.
|LdU||Lid cannot unlock.||The washer detects that there are objects on washer lid preventing it from unlocking. Remove objects, such as a basket of laundry, from the top of the washer.|
|LF, Lo FL or F8 E1||The washer is taking too long to fill.||
There may be some problem with the water supply going to the washer. Check the water supply: Turn on the water, and check the household water supply to see if the hot and cold water faucets are turned on. Make sure to open both faucets completely for proper fill.
NOTE: Both Hot and Cold water must be supplied to the washer.
For more information on how to remove the error code, check F8 E1 or LO FL Error Code in Display
|lid||The washer lid was left open.||
Close the lid to clear the display. If the lid is left open for more than 10 minutes, the cycle will reset and water in the washer will drain.
If washer has drained, start cycle over. Do not add more detergent, as the clothing should already be penetrated with water and detergent.
|Ofb||The washer load is out of balance.||
The washer is running a load-balance correction routine. Allow the washer to continue.
Try the following steps first:
Use Bulky/Sheets Deep Water Wash cycle for oversized, nonabsorbent items such as comforters or poly-filled jackets. Other items are not appropriate for Bulky/Sheets Normal cycle. See “Cycle Guide”in your Use and Care manual for more information on loading.
|OL||The washer load too large.||If an overload is detected, the washer will drain any water and detergent in the washer. Remove several items and add HE detergent. Close lid and press START/PAUSE.|
|PF||The wash cycle was interrupted by a power failure.||Touch and hold START to restart the washer cycle or press POWER to clear the display.|
|Sud||There are excessive suds in washer.||Be sure to always use HE High Efficiency Detergent in the washer. Learn more about HE Detergent use in your Washer.|