Skip to main content
Amana Appliances

Using the Wireless Remote Timer and Thermometer

How to Use the Wireless Remote and Meat Probe in My Amana Oven

Install the batteries

There is a strip under the battery cover to prevent battery drain in shipping.  Please remove the strip before continuing with these instructions (you may need to remove the battery compartment to avoid breaking the strip). 

  1. Remove the battery cover on the back of the thermometer. 
  2. Insert 4 AAA 1.5V batteries as indicated by the polarity symbols (+ and -).   
  3. Replace the battery cover

To preserve the batteries, turn both units On when in use and OFF when not in use. If readings grow dim or irregular, the batteries may need to be replaced.      

 wireless_thermometer_battery_installation.jpg

Using the Meat Probe

Wireless Remote Timer and Thermometer Components:

wireless_thermometer_handheld_unit.jpg      wireless_thermometer_probe.jpg

  1. Connect the meat probe. Locate the probe port on the side of the thermometer(Transmitting Base).  Insert the probe connector plug into the port.  (See Fig. 1).  

wireless_thermometer_probe_insert.jpg

  1.  Turn it "ON". Turn on Handheld Unit and Transmitting Base Unit by using the On/Off switch on each.  Base LED Light will be green when powered ON.  Turn off both devices when not in use.

  2. SYNC the meat probe. When both devices are turned on, "SYNC" will appear in the upper left corner of the LCD screen indicating they are synced.

  3. °C/°F Temperature Display Switch between °C and °F using the button on the top side of the thermometer(Handheld Unit). 

wireless_thermometer_buttons.jpg

  1. Insert the probe. Insert probe tip into the center of the thickest part of the meat, ensuring the tip has not pierced through the other side of the meat.  Do not expose any part of the probe to open flame. 

  2. Set the temperature.  There are 2 Temperature modes:  Preset and Manual.

    1.  Preset:  Only "Meat" and "Taste" should be underlined on the LCD screen.  Press the MEAT button to scroll through the 8 meat choices:  stop when desired meat choice is highlighted.  Press the Taste button to scroll through the Meat doneness settings:  stop when desired meat doneness appears.

    2. Manual: Press the "+" or "-" button to override the Preset Setting and to enter into the Manual Setting.  Only "TEMP" should be underlined on the LCD screen.  Press "+" or "-" to increase or decrease Set Temp.  Stop when desired Set Temperature is reached.

  3. Set the timer.  Press MODE to select TIMER. Timer is selected when underlined.  When the count-up or count-down is finished, the thermometer will beep and the LCD screen will flash. Press any key to silence the alert.

    1. To set a count-down time, press H/M (Hours/Minutes).  

      1. Press once for Hours. Hours will flash when in this setting.  Press again for Minutes.  Minutes will flash when in this setting. 

      2. Press + or - to increase or decrease the displayed time.

    2. To start a count-up without setting a time, press to start from zero.  

      1. To pause the timer during a count-down or count-up, to clear timer, press button to pause count-down or count-up.  

      2. Once paused, press “+” and “-” at the same time to reset to zero.  

  4. When Current Temperature has reached Set Temperature, the alarm will beep and the LCD screen will flash.  Press any button to silence the alarm.

Cleaning the Meat Probe 

  1. Unplug meat probe from the thermometer. 
  2. Hand wash meat probe ONLY using mild soap and hot water. 
  3. Rinse thoroughly. 
  4. Dry completely with a soft cloth.

Wipe Handheld Unit and Base Unit clean.

 

  • Was this article helpful?