If the washer has an F8 E1 error or LO FL error, the door will be locked, and the control will be unresponsive. Press the power button, and the washer will start a drain routine which takes approximately 8 to 10 minutes, during which time the pump will run continuously. The control will not accept any input during this time. Please wait 10 minutes before trying to perform any functions.
CLICK HERE for more explanation on the F8 E1 Error Code
Is the household water supply turned on?
Both the hot and the cold water faucets or valves must be turned on and fully open. Check the household faucets to see if the hot and cold water faucets are turned on. Make sure to open both faucets or valves completely for proper fill.
Is the water inlet hose kinked?
Check for any kinks in inlet hoses, which can restrict water flow.
CLICK HERE for more information on the water supply
Are you using an Anti-flood device or controls?
Whirlpool recommends that appliances be direct connected to the water supply for optimum machine performance. Using anti-flood devices can reduce the water pressure and amount of water entering the appliance.
CLICK HERE for more information on the use of flood safe devices
Is the drain hose correctly installed?
Check drain hose for proper installation. Use the U-shaped drain hose form on the drain hose and securely attach to drainpipe (standpipe) or tub. Check that only 4.5" (113 mm) of drain hose is in the drainpipe (standpipe). Do not tape over the drain opening.
The drainpipe (standpipe) height requirements minimum is 39" (99 cm).
Make sure the drain hose is not kinked or clogged. Straighten the hose for adequate water flow. Remove any blockage from the drainpipe of utility sink.
CLICK HERE for more information on how to install the drain hose
To remove displayed code:
- Press the Pause or Cancel button twice
- Press the Power button once
NOTE: The method for removing the displayed code varies by model
If code is still displayed:
- Unplug the washer or disconnect the power for one minute.
- Plug in the washer or reconnect the power.
- Re-select the cycle and press Start.
Still need help?
Please contact us at 1-866-616-2664, or by live chat, email or mail.